The worm gear screw jacks are widely used in our daily life, and we can see the use of screw jack in iron and steel enterprises or in machinery factories or in hardware factories. So how do you ...
Worm gear screw lifts are widely used, but at the same time, there are often some problems. For these problems arising from the worm gear screw lifts, Lude Transmission will organize and share solutio...
Worm gear screw jacks should not be driven into their mechanical limits, particularly models with higher speeds. Simple stroke control can be provided with limit switches. These can be mou...
When the single screw jack cannot meet the need or is very big, we think of the multiple screw jacks system.Screw Jack Systems offer comprehensive lifting and positioning design solutions for a wide v...
Worm gear screw jacks can be used individually and in multiple linkage. Multiple screw jacks can make up to screw jack system together with other accessories like shaft,couplings,pillow block,motor or...
The relationship between work continuation rate and ambient temperature is shown in the table. When the ambient temperature exceeds 40 °C, consideration should be given to reducing the work rate.
The lifting speed of the worm gear screw jack is limited.If the lifting speed is too fast, the friction heat and the wear are very strong, and the service life of the screw lift will be greatly discou...
The upright screw jack is usually used to lift or push up objects(screw top end is up the mounting base). The inverted screw jack is usually used to lift or press down object(screw top end is below th...
Usually Lude bevel gearboxes are filled with gear oil for normal operation before leaving the factory and are ready for use.The standard gear oil is HD320~680. Notes:Delivered gearboxes by air/express...
According to detailed need, Ludetransmission can choose multiple screw jacks to make up a screw jack system.The system can be of different screw jack arrangements,like I/T/H/U type etc. When multiple ...
For translating screw jacks, key-way is a common way to realize the anti-rotation for the screw jack.In fact, there is another way,that is to use a special square tube. A square guide tube is attached...
Question: Does it matter which shaft I use as my input shaft of the bevel gearbox? Answer: When using a 1:1 ratio miter gearbox,it does not matter which shaft is used as the input shaft as the speed w...