Cubic Ball Screw Jack are an excellent solution for industrial lifting, lowering, pushing and/or pulling applications that require higher efficiency, greater accuracy or faster travel speeds than offered by Worm Gear Screw Jacks.

SWL Series Worm Gear Screw Jack is a basis jack-up part, accomplish the functions such as lifting , dropping ,pushing and inverting through worm gear drives screw .

5 KN Small Screw Jacks, also called 5 kN Cubic worm gear screw jack or small worm screw jack.

Lude Transmission stainless steel screw jacks are specifically designed for positioning and lifting applications that are located in wet, corrosive and harsh environments. They can be trapezoidal type or ball type. Metallurgical properties of stainless steel allow it to remain ductile even at very low temperatures.These mechanical jacks are available in 2 ton through 25 ton capacities. Upright or inverted jacks operate at full capacity in tension or compression. Features: All exposed surfaces and components feature stainless steel or bronze construction Nitrile rubber seals protect all internal mechanisms. Tapered or ball thrust bearings provide rugged reliability Choose one of four standard end conditions Protective boots available Anti-backlash devices available

SWL Stainless Steel Hand Crank Screw Actuator is a basic lifting component. It has many characteristics, such as compact structure, small size, light weight, wide power source, no noise, convenient installation, flexible use, multiple functions, various supporting forms, high reliability and long service life. It can be used alone or in combination. It can accurately control and adjust the height of lifting or propulsion according to a certain program. It can be driven directly by motor or other power or manually. It has different structure type and assembly type, and lifting height can be customized according to user's requirements.  

The Worm Gear Screw Jack are ideal solutions for applications where electricity or power generators is inconvenient or dangerous, light weight, low duty cycle, low target cost and short travel length.

Ball screw jacks combine the gear unit with a linear drive performed by a ball screw that, in comparison with the traditional acme screw, offers following advantages: • higher total efficiency • longer life of the whole linear drive system The following two comparative examples give an idea of the higher efficiency that can be obtained with this system: • considering a screw jack consisting of a worm gear with linear drive performed by an acme screw,  the total efficiency of the screw jack is between 10 % and 40 % • considering a screw jack consisting of a worm gear with linear drive performed by a ball screw, the  total efficiency of the screw jack is between 30 % and 70 % Our Ball screw jacks are available in two different models: • travelling screw (Model A,namely translating type) • travelling nut (Model B,namely rotating type)

Screw jack/lift is a basis jack-up part, accomplish the functions such as lifting, drop, push and inverting through worm gear drives screw.

Cubic Translating Acme Screw Jack available load capacity is from 500kg to 100ton.

Screw jack is used in applications where linear motion is required. Lifting of any load, pushing or pulling of mechanical equipment, adjusting of tight clearances of mechanical parts can be done by screw jacks. Mechanical capacity of screw jacks is between 5kN and 2000kN, Jack screws can be used as linear motors, linear actuators, or mechanical lifts depending on type of motion. Working Principle of Screw Jacks Main components of screw jacks are: trapezoidal lifting screw, worm screw, worm gear and gear housing, Worm screw is rotated manually or by motor. Worm gear is rotated by worm screw. The lifting screw moves through the rotating worm gear. The linear motion speed of lifting screw depends on thread size and rotation ratio of worm gears.

Mini Screw Jack available load capacity is from 500kg to 100ton.